Pay attention to the following three points when installing synthetic resin tile to avoid many problems

TIME：2023-02-07

1. During the installation of synthetic resin tile, we need to study and select the installation according to our local wind direction data. In order to make the tile body more firmly installed on the roof, at least one wave should be overlapped between two resin tiles horizontally, and two waves should be overlapped in windy areas; As for longitudinal overlap, it should be 20-25cm, and at least 40cm in windy areas. Where the tiles are overlapped, that is, where the purlins are in direct contact, they need to be fixed with self-tapping screws. It is recommended to use 4 sets of nails per square meter, and 6 sets are required in windy areas.

2. In order to ensure the same waveform of the positive ridge tile, the synthetic resin tile must be installed synchronously and symmetrically on the two slopes of the roof.

3. The fixing piece of synthetic resin tile can be fixed with a waterproof pad padded with screws, and then properly tightened with a wrench. It also needs to be covered with a waterproof cover to prevent the screws from being corroded by moisture and affecting the firmness.

Finally, if you want to avoid some problems in the use of synthetic resin tile, you must understand the standard installation and precautions of resin tile before installation; Otherwise, we must find a professional installation team. The synthetic resin tile is of high quality and can be installed once and for all in combination with the standard installation.